We will verify Kirchhoff’s Voltage Law (KCL) & Kirchhoff’s Current Law (KCL) in series and parallel combination of LEDs and resistors.

In this project, we will verify Ohm’s law in a circuit by using different value resistors and also measure & verify current using a multimeter.

You build a temperature-controlled switch using a voltage-divider circuit and a preset and a thermistor. It’s a fun project for classrooms.

Build transmitter & receiver circuits using an IR LED & a photo-diode; alarm gets triggered on detection of intrusion & beeps continuously.

Boost the energy of a 1.2 volt cell up to 2 volt to glow an LED in a series RLC circuit; a perfect project based on inductors (coil).

Build & realize a bridge rectifier using diodes, a 12-0-12 V AC step-down transformer & a load resistor; measure the rectified output.

Build & realize a bridge rectifier using diodes, a 12 V AC step-down transformer & a load resistor; measure the rectified output.

You will verify the Wheatstone Bridge principle and experimentally calculate the value of an unknown resistor using a potentiometer.

This project will test the factors affecting the speed (RPM) of the DC motor. Is it the voltage or current? A must-have for robotics clubs.

A motor-driving circuit used in Robotics to control the direction of a DC motor using transistors; a must-have for maker clubs.